Full width rock and roll bed frame supplied as a painted bare frame.
It will require fixings, plywood base & backrest and foam padding to complete it. We recommend using 9mm thick plywood and 4 inch foam padding to achieve the best results.
For fitment into a T25 it will require the furthest rear angled floor brackets to be re-profiled to better meet the different floor shape.
1.5 metre wide
T2 Bay 1968-1979 | T2 Split 1950-1967
Also, I'd be looking to fit two 3 point seat belts using the brackets you sell. Do these brackets and the seat belt anchor points bolt to the seat, or do I need to drill holes.
Lastly, I can't find a triple set of covers to make a bed, only sets of two. Do you sell a complete bed set? Or even the foam padding?
The bed secures to the seat belt mounting holes on the rear wheel housings as do the lower mounts for the seat belts. The seat belt brackets also secure to the vehicle body via a M8 bolt mid way on the rear most panel and directly under the rear most side window too.
Top with 9mm thick plywood and a 4" foam padding for best results. Most people have quite specific interior trim requirements and bespoke covers are normally required hence not available as a stock item.
A coachtrimmer will be able to do this for you.