Manifold centre section, PICT carbs, better flow [10] AC129244
Part information
Description
Aftermarket inlet manifold centre section for use with stock PICT carburettors. This centre section flows better than stock increasing performance. Supplied with pre-heat tubes. There are two mounting holes to took 34mm and smaller carbs.
Quality
Top quality
Fitting Info
Has a tapped hole for vaccum take off pipe, hose barb not included.
For Vehicles
All twin port aircooled T1 engines 1300-1600cc
Other parts that may also be of interest
Inlet manifold single port (1.3-1.6)
Inlet manifold rubber,1.3-1.6 [20]
Inlet manifold end, Right, Twinport 1.6, Genuine VW
Clip, Axle Gaiter / heater hose, S/steel (40-60mm)
Clip, inlet manifold, small (25-40mm) [20]
Inlet manifold gasket, single port 1300/1500/1600
Manifold ends, EMPI, pair Or use 113-129-709/G & 710/D
Inlet manifold, Twinport, new 1.6, 34mm [10]
Inlet manifold, 1200cc
Clip, Swing axle boot small / inlet manifold large (30-45mm)
Inlet Manifold Gasket, Twin-port (Manifold to head)
Broached Crank Bolt & Washer for 3/8" Drive
Manifold end kit conversion for single port engines
Manifold boots, urethane, red, pair [20]
Nut, M6,Single port inlet manifold/wiper (NOT sump N0110624)
Nut, M8 general use
Inlet Manifold Gasket, 34HP 1200, 2 Reqd, 62-
Washer, Oil relief valve Type4 & WBX, Inlet manifold 25hp
Stud single port inlet manifold / Early oil pump [50]
Stud, Intake Manifold / Exhaust, Genuine, M8x38