Manifold Ends

A: Twin Port End Castings

Supplied with gaiters. Pair.

B: Single Port (conversion) End Castings

Allows you to fit twin port manifolds to single port engines. Tip: check fit and file excess metal as neccesary before installation. Supplied with boots and clips. Pair.

Manifold Boots

Urethane boots (as pictured). Pair.

Standard, stock boots. Sold individually.

Large boot clip. Sold individually.

Small boot clip. Sold individually.

Performance PICT Manifold

Suitable for any stock carb. Use with Twin Port or our Single Port manifold ends. Better flow than standard manifolds to give a small increase in horsepower.

Weber 32/36 Manifold

Manifold kit (supplied with pre-heat pipes, support bracket and hardware) - Beetle or Bus.

Replacement pre-heat pipes with spare support bracket

Weber 34 ICT Manifolds

Supplied as a pair, with studs, nuts and gaskets.

A: Single port - all models

B: Twin port - Beetle or Bus

B: Twin port - Type 3

EMPI/Kadron Manifolds

Supplied as a pair, with studs, nuts and gaskets.

Beetle or Bus - twin port

Weber IDA Manifolds

Supplied in pairs with studs, nuts and gaskets.

EMPI standard IDA manifold kit

EMPI racing IDA manifold kit (has enough material for big porting)

Weber IDF / EMPI HPMX / Dellorto DRLA Manifolds

Supplied in pairs with studs, nuts and gaskets. Even those these are the late offset type, you may still neeed to 'clearance' late standard fanshrouds. For Beetle or Bus.

Normal offset

SCAT Mini-D Port heads

SCAT Wedge Port heads

Eliminator heads

Inlet Manifold to Cylinder Head Gaskets

Twin port heads

Fibre, supplied in pairs.